How the lumber calculator works
Wall framing mode counts the studs for a given wall length, stud spacing, corners and openings, and the top and bottom plates. Board feet mode converts the thickness, width and length of your boards into board feet, the unit most lumber yards price in.
Both modes include the waste factor you pick, because some boards will be crooked, split or cut short.
Formulas used
- Studs = wall length / spacing + 1, plus 2 per corner and 2 per opening
- Plates = 3 x wall length (one bottom, two top), divided by board length
- Board feet = thickness (in) x width (in) x length (ft) / 12 x pieces
Frequently asked questions
What is a board foot?
A board foot is a volume of wood 12 x 12 x 1 inch thick. A 2 x 4 that is 8 ft long is 5.33 board feet.
Should I use 16 or 24 inch stud spacing?
16 inches on centre is the default for load-bearing walls. 24 inches saves lumber on non-structural walls where your local code allows it.
Why add waste to lumber?
Studs get culled for bows and splits, and off-cuts are often too short to reuse. 10 percent is a common allowance.